Pairing the LED transmitter to the Hub If your transmitter did not pair successfully with the hub when you took it out of the box, try removing and rein...

Your Hub, LED transmitter and LED sensor can be used on any electricity meter which has a LED pulse output.  Look for a flashing LED on the meter, with t...

The Hub can be reset by pressing with a pen or pencil the reset button (E) on the back of the hub for 3 seconds. See the table below for the details of th...

Your Hub is designed to only send low amounts of data via your broadband router. Per day, the Hub should send less than 10MB.  

The battery life is approximately one year under normal operating conditions and temperature.

The standing charge is applied in the first hour after midnight. This means you will see the standing charge appear in the geo Home app along with any elect...

Before starting the linking process, please ensure your Hub is installed correctly, please refer to your set up guide or Quick Start Guide, and ensure that ...

When the Hub is reset or updating the firmware During the Hub reset or updating the firmware, the LEDs will behave as shown in the table below. LED Beh...

In order to complete the setup of the LED transmitter within the app, there are two pieces of information that are required: The number of LED flashes pe...

If you pay monthly, then the best place to start is entering how much you pay for your electricity and gas, this information should be on your bill.  If...