The majority of residential properties in the UK use a single-phase electricity feed for power, to have a product that suits this, we would recommend ensuri...

Temperature reports start after 30 minutes to allow for the settling time as your display warms up.

Press and hold all three buttons on the monitor for 3 seconds until the display reads “RESET?” use – button to select “yes” and + button for “no”.

Press and hold all three buttons on the monitor for 3 seconds until the display reads “RESET?” use – button to select “yes” and + button for “no”. You can...

If after following the set up process nothing appears on your display unit at all, you may have a faulty component. Please contact geo support using the co...

The electricity monitor provides a good indication of your approximate electricity consumption, but is not intended to measure consumption with 100% accur...

The battery life is over two years. When the battery indicator starts to flash on your monitor’s screen you can replace the three AA batteries in the tran...

This means that your display unit is not in range of your transmitter. The maximum range of the display unit is 30 meters and the signal can be detected t...

Your display uses around 600mW of electricity, which equates to less than £1 per year.

At geo, we sell a Minim+ with an LED connector and a Minim+ with a CT Connector. The easiest way to tell what would work best for you, is by looking at ...